Sloping a floor is necessary for proper drainage.
When installing a floor drain on most indoor floor surfaces, it is important to slope the floor slightly so that water will flow toward the drain efficiently. Failure to achieve adequate slope will result in standing water problems; too much slope will create a poor feel to the floor and cause the unsettling sensation of the room being crooked or downhill. Properly sloping a floor/drain combination will give the room a more professional feel and appearance.
Instructions
1. Remove the existing floor covering in the room that will be sloped for a drain. When you are ready to begin the sloping procedures, the remaining flooring surface should be either wood (such as plywood or hardwood) or concrete.
2. Lay down a waterproof floor liner covering the entire floor surface so that the floor below will be impenetrable to water. Make sure that you fold the edges of the liner up so that water cannot flow through the folds to the surface beneath. Most liner packages contain detailed instruction accomplish this, as well as glue any unfolded seams for large rooms.
3. Identify the location for the drain (either an already existing drain, or a drain to be added later) such as in the center of the room in a bathroom or a slightly offset drain in a walk-in closet. Measure the distances to this drain location from the surrounding walls.
4. Cover the entire floor with wire mesh, and get it to lay as tightly as possible against the waterproof floor liner. Be careful not to cut or tear the waterproof floor liner with the wire mesh. Leave a 6-inch hole in the mesh where the drain will be.
5. Calculate the amount of slope to be created from each wall. The preferred slope is between one-quarter and one-eighth inch per running foot of floor length. As a rule of thumb, all areas around the drain should have a similar slope. To calculate this, multiply the length in feet of the farthest wall from the drain and multiply that result by 0.125. This will be the height in inches of the added floor surface at the farthest edges from the drain. Mark this location on the walls surrounding the drain.
6. Attach the bottom flange of the drain assembly to the drain pipe if installing a new drain. If using an existing drain, remove the existing drain cover.
7. Mix the mortar in a wheelbarrow per the manufacturer's instructions. Spread the mortar with a hand trowel across the surface of the floor, starting at the outside edges of the room and working toward the drain. At the outside edges or the room, be sure to build the mortar up to the lines you have marked on the walls. Near the drain, the mortar should rise to just below the drain assembly.
8. Smooth the surface of the mortar with a trowel, so that you have a uniform finish running across the room, with a gradual slope toward the drain. Allow the mortar to dry completely before installing any floor-finishing products, such as tile, cement or paint.
Related posts
The ground drain installed in the primary drainpipe.A Do It Yourself basement drain installation could be carried out for a variety of projects, together with a toilet, shower or laundry tub. Freq...
Dirty drains can harbor drain flies.Common drain flies live and breed in drains and thrive on the sludge found there. The issue is rarely kitchen and tub drains, since these drains are flushed out...
Connecting a PVC pipe to a water heater drain pan helps prevent a leaky tank from flooding the floor under the water heater. Water heater drain pans are usually 2-inches deep and have a 1-inch dia...
A dishwasher cannot drain if its motor is not operating properly.It can be an unpleasant surprise to open your dishwasher at the end of a cleaning cycle and find that it's still full of water. Whi...
The Kenmore Elite series of dishwashers are popular with homeowners because of the reliability and durability of the appliance. This does not mean that you will not have to perform routine mainten...
